Motorola Solutions MSC-122 인증시험

ITExamDump덤프공부가이드는 업계에서 높은 인지도를 자랑하고 있습니다. ITExamDump제품은 업데이트가 가장 빠르고 적중율이 가장 높아 업계의 다른 IT공부자료 사이트보다 출중합니다. ITExamDump의Motorola Solutions인증 MSC-122덤프는 이해하기 쉽고 모든Motorola Solutions인증 MSC-122시험유형이 모두 포함되어 있어 덤프만 잘 이해하고 공부하시면 시험패스는 문제없습니다.

그렇게 많은 IT인증덤프공부자료를 제공하는 사이트중ITExamDump의 인지도가 제일 높은 원인은 무엇일가요?그건ITExamDump의 제품이 가장 좋다는 것을 의미합니다. ITExamDump에서 제공해드리는 Motorola Solutions인증 MSC-122덤프공부자료는Motorola Solutions인증 MSC-122실제시험문제에 초점을 맞추어 시험커버율이 거의 100%입니다. 이 덤프만 공부하시면Motorola Solutions인증 MSC-122시험패스에 자신을 느끼게 됩니다.

ITExamDump는IT업계전문가들이 그들의 노하우와 몇 년간의 경험 등으로 자료의 정확도를 높여 응시자들의 요구를 만족시켜 드립니다. 우리는 꼭 한번에Motorola Solutions MSC-122시험을 패스할 수 있도록 도와드릴 것입니다. 여러분은Motorola Solutions MSC-122시험자료 구매로 제일 정확하고 또 최신시험버전의 문제와 답을 사용할 수 있습니다. Pass4Tes의 인증시험적중 율은 아주 높습니다. 때문에 많은 IT인증시험준비중인분들에세 많은 편리를 드릴수 있습니다.100%정확도 100%신뢰.여러분은 마음편히 응시하시면 됩니다.

Motorola Solutions MSC-122인증시험패스는 아주 어렵습니다. 자기에맞는 현명한 학습자료선택은 성공을 내딛는 첫발입니다. 퍼펙트한 자료만의 시험에 성공할수 있습니다. Pass4Tes시험문제와 답이야 말로 퍼펙트한 자료이죠. 우리Motorola Solutions MSC-122인증시험자료는 100%보장을 드립니다. 또한 구매 후 일년무료 업데이트버전을 받을 수 있는 기회를 얻을 수 있습니다.

시험 번호/코드: MSC-122

시험 이름: Motorola Solutions (Deploy WLAN Solutions)

MSC-122 덤프무료샘플다운로드하기: http://www.itexamdump.com/MSC-122.html

NO.1 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B

Motorola Solutions dump   MSC-122최신덤프   MSC-122시험문제   MSC-122

NO.2 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A

Motorola Solutions덤프   MSC-122   MSC-122

NO.3 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A

Motorola Solutions   MSC-122 pdf   MSC-122기출문제   MSC-122   MSC-122시험문제

NO.4 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D

Motorola Solutions dump   MSC-122   MSC-122 dump

NO.5 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C

Motorola Solutions   MSC-122   MSC-122   MSC-122 dumps

NO.6 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C

Motorola Solutions dumps   MSC-122최신덤프   MSC-122   MSC-122

NO.7 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A

Motorola Solutions덤프   MSC-122   MSC-122

NO.8 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B

Motorola Solutions최신덤프   MSC-122   MSC-122   MSC-122

NO.9 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A

Motorola Solutions자료   MSC-122 dump   MSC-122   MSC-122 dump   MSC-122   MSC-122

NO.10 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C

Motorola Solutions dumps   MSC-122   MSC-122자격증   MSC-122 pdf   MSC-122

NO.11 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B

Motorola Solutions최신덤프   MSC-122   MSC-122기출문제

NO.12 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C

Motorola Solutions dumps   MSC-122시험문제   MSC-122덤프   MSC-122   MSC-122

NO.13 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D

Motorola Solutions자료   MSC-122   MSC-122   MSC-122   MSC-122   MSC-122최신덤프

NO.14 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A

Motorola Solutions dump   MSC-122인증   MSC-122

NO.15 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D

Motorola Solutions   MSC-122자료   MSC-122 pdf

ITExamDump의Motorola Solutions인증 MSC-122덤프는 인터넷에서 검색되는Motorola Solutions인증 MSC-122시험공부자료중 가장 출중한 시험준비 자료입니다. Motorola Solutions인증 MSC-122덤프를 공부하면 시험패스는 물론이고 IT지식을 더 많이 쌓을수 있어 일거량득입니다.자격증을 취득하여 자신있게 승진하여 연봉협상하세요.